Wouldn’t advise turning off ipv6. We are probably getting near the point where some public services will disable or offer v4 as only best effort, and when this happens, your connectivity will be broken for certain things if you disable v6. Heck, it’s to the point now where all my home hosted services are v6 only.
The better solution is to just get a VPN that supports ipv6 like airvpn or mullvad. I think pia disables ipv6 while the tunnel is up, which is better than disabling ipv6 altogether.
To validate the tunnel is working properly you can use something like this.
There is also a Torrent Address detection section, that when you activate it, will provide a magnet link that will show your ip to ensure that it is tunneled properly.
Many ISPs are no longer handing out even 1 public ipv4 address per account, and instead opting for CGnat which further breaks and stratifies the internet.
Tmobile for example is 464xlat which is even worse than cgnat since it requires tampering with dns responses.
Given the situation many ISP are in, most serious companies offering services on the internet have supported ipv6 for a long time now in order to offer the most competitive service possible. And with cloudflare now serving up a large amount of traffic, a lot of all traffic is v6.
My ISP routinely has problems on IPv4. Even while it’s fully operational with very low ping, IPv4 performance is poor compared to IPv6. Add in NAT, port forwarding and all the mess IPv4 brings into the picture I can’t believe people are still advocating for disabling IPv6.
I actually had to disable ipv6 just because Halo Infinite wouldn’t load the UI. A couple websites were unreachable with it on too. Seems like it will still be awhile.
There’s an issue with your VPN.
What VPN service do you use?
It probably isn’t which one that’s the problem, it’s more likely your setup.
If you can, try disabling IPv6 entirely, turn it off in your operating system and your router. I’d bet you’re leaking past the VPN that way.
Wouldn’t advise turning off ipv6. We are probably getting near the point where some public services will disable or offer v4 as only best effort, and when this happens, your connectivity will be broken for certain things if you disable v6. Heck, it’s to the point now where all my home hosted services are v6 only.
The better solution is to just get a VPN that supports ipv6 like airvpn or mullvad. I think pia disables ipv6 while the tunnel is up, which is better than disabling ipv6 altogether.
To validate the tunnel is working properly you can use something like this.
https://ipleak.net/
There is also a Torrent Address detection section, that when you activate it, will provide a magnet link that will show your ip to ensure that it is tunneled properly.
Dude, it’ll be a longer time than this guy is going to be on his ISP before he’ll need to worry about ipv6.
OP - feel free to disable it, IMO.
Seriously; they’ve been talking about v6 for like 3 decades now. I’ll believe it when I see it.
Many ISPs are no longer handing out even 1 public ipv4 address per account, and instead opting for CGnat which further breaks and stratifies the internet.
Tmobile for example is 464xlat which is even worse than cgnat since it requires tampering with dns responses.
Given the situation many ISP are in, most serious companies offering services on the internet have supported ipv6 for a long time now in order to offer the most competitive service possible. And with cloudflare now serving up a large amount of traffic, a lot of all traffic is v6.
Believe it or not, but IPv6 is here and gaining ground.
deleted by creator
My ISP routinely has problems on IPv4. Even while it’s fully operational with very low ping, IPv4 performance is poor compared to IPv6. Add in NAT, port forwarding and all the mess IPv4 brings into the picture I can’t believe people are still advocating for disabling IPv6.
deleted by creator
Have you ever tried NATing v6 on a router from 2019? good fucking luck
Mullvad doesn’t allow portforwarding anymore iirc
I actually had to disable ipv6 just because Halo Infinite wouldn’t load the UI. A couple websites were unreachable with it on too. Seems like it will still be awhile.
WireGuard is increasingly popular as far as I can tell. And if I understand correctly, designed more for IPv6.
I just noticed I have ipv6 disabled in Mullvad. It has caused me no issues. Should I enable it?
If you want to, then sure. For torrenting, it’s not necessary, but may be helpful. I do occasionally see ipv6 peers.
I only heard good things about mullvad vpn.
I heard they stopped port forwarding though.
Express VPN